Antenna Dual-Band WiFi 2.4GHz 5GHz 7dBi Omni w/ RP-SMA

$7.44
SKU:
ADD7ext
Brand:

Availability:
In stock
Weight:
0.15 LBS
Dual-Band dipole antenna: 2.4GHz 5GHz 7dBi omnidirectional w/ RP-SMA male. Suitable for exterior and interior use.
Bulk Pricing:
Buy in bulk and save

Bulk discount rates

Below are the available bulk discount rates for each individual item when you purchase a certain amount

  • Buy 20 - 39 and get 1% off
  • Buy 40 - 59 and get 2% off
  • Buy 60 - 79 and get 3% off
  • Buy 80 - 99 and get 4% off
  • Buy 100 - 299 and get 5% off
  • Buy 300 or above and get 10% off
Write a Review

Antenna Dual-Band Omnidirectional

Suitable for 802.11abgn and 802.11ac with RP-SMA (male) connector.

Compatible with Wireless Access Points & cards that have RP-SMA antenna jacks.

Omni dipole antenna: Radiates signal with a beam of 360 degrees; also receives signal from 360 degrees around it

  • As client antenna: Connect to access points in any direction.
  • As access point antenna: Provides signal to clients in all directions (360-degree horizontal beamwidth).
  • Compliant with 802.11ac, 802.11n & 802.11g
  • Mounts directly onto RP-SMA (female) connector of access point, bridge, client, or booster
  • Portable size: Easily fits in laptop case.
  • We have two versions of this antenna:
    • Articulating Right Angle: Bottom section of antenna has hinged joint that bends up to 90-degrees. Can be used either straight or with joint-bend. Part# is ADD7ext
    • Fixed Right Angle: Bottom section of antenna has a fixed right-angle joint at 90-degrees. The fixed right angle provides weather-resistance / waterproofing. Part# is ADD7extFRA.

Compatibility with wireless standards & applications: This omni directional dual band antenna's range of frequency band compatibility in the 2.4GHz and the 5.8GHz frequencies, its excellent low broadband VSWR at < 1.7, and impedance matching to 50 Ohm gear, makes it suitable and compliant for all the following applications:

  • IoT wireless & M2M: 802.11AC, 802.11N, 802.11G, 802.11B, 802.11A, 802.11AH.
  • As access point antenna: Provides signal to clients in any direction (360-degree horizontal beamwidth).
  • As client antenna: Connect to an access point in any direction.
  • Designed for wireless 802.11ac and other Dual Band 2.4GHz / 5.8 GHz applications.
SPECIFICATIONS
Frequency & Gain 5dBi ± 0.5dBi @ 2400~2500MHz
7dBi ± 0.5dBi @ 5100~5800MHz
V.S.W.R f2.0:1
Dimensions Length: 390mm x Diameter: 14mm
(15.4 x .55 in)
Efficiency >81% @ 2400 ~ 2500MHz
>73% @ 5150~5850MHz
Polarization Linear vertical
Impedance 50 Ohm
Connector RP-SMA male
Environmental Operation Temperature: -40 ~ +65
Storage Temperature: -40 ~ +80

TEST RESULTS for FREQUENCY RANGES:

report antenna

The antenna exhibits stable performance over the evaluated range of approximately 2.40 to 2.50 GHz, maintaining an impedance match reasonably close to the nominal 50 Ω system impedance across most of the band; the S11 parameter analysis shows a point of best matching around 2.44 GHz, where the VSWR decreases to approximately 1.57, corresponding to a Return Loss near −13.1 dB, while at the upper end of the range (around 2.50 GHz) the VSWR is approximately 2.12, equivalent to a Return Loss of about −8.9 dB.

Frequency range Assessment Rating Compatible technologies
2.40–2.50 GHz Very Good ★★★★ Wi-Fi 2.4 GHz (802.11b/g/n), Bluetooth (Classic & BLE), ZigBee, Thread, ISM band IoT devices, wireless sensors and telemetry systems, and embedded RF communication modules operating in the 2.4 GHz band.
Stable impedance behavior referenced to 50 Ω across the evaluated band. The best matching point is observed around 2.44 GHz, where VSWR decreases to approximately 1.56, corresponding to a Return Loss near −13.2 dB. Toward the upper end of the band (around 2.50 GHz), VSWR reaches approximately 2.12, equivalent to a Return Loss close to −8.9 dB. These values indicate efficient power transfer in the central portion of the ISM 2.4 GHz band with moderate reflection levels toward the band edges.
 

ROHS compliant: The entire product is ROHS compliant (connector and antenna).

  • RP SMA Connector Materials Composition
  • RP SMA Characteristics and Key Information
  • Mounts directly onto RP-SMA(female) connector of access point, bridge , USB WiFi adapter, or booster. See other magnetic bases that fit this antenna and have antenna cables with other types of connectors.
  • Articulating (Bendable) Right Angle: This antenna can be angled up to 90 degrees (articulating right angle) or positioned straight. The articulating (bendable) right-angle isn’t weatherproof: Water can seep into the angled part of the antenna. Articulating right-angle antennas are therefore recommendable for indoor use or protected outdoors, i.e. under an eave. If you need a weatherproof dipole antenna, you should choose either a straight dipole or one with a fixed right angle. See our weatherproof antennas.

RELATED ANTENNAS 4.9-6.0GHz

 

COMPATIBLE MOUNTS & TECH SUPPORT PAGES

All of our antennas pass QC test before we ship them.