Stainless Steel Pole & Wall Mount w/ U-Bolt Kit

Rugged, corrosion-resistant pole and wall bracket for mounting antenna masts or conduit to a pole or to a flat surface. The all-stainless construction and dual U-bolt clamp deliver a secure hold in coastal and high-UV environments—ideal for Wi-Fi, cellular/LTE, LoRa, GPS, CCTV, and weather instruments.

C Jaw Bracket & UBolts: Sstainless steel U-BOLTS (included) can be used to secure the mount to a pole up to to 2-inch (40mm) outer diameter, or use the set-screws kit to secure the mount to a wall.

Bracket dimensions: 143x90x2mm Stainless steel mounting bracket can be mounted vertically or horizontally.

Heavy-duty articulating mount that is adjustable to face any direction. Stainless steel, suitable for high-wind conditions and larger antennas.

For Outdoor Antennas & Masts

All-stainless hardware: bracket, U-bolts, nuts, and lock washers resist rust and galvanic corrosion outdoors.
Dual U-bolt clamp: two U-bolts spread the load and prevent mast creep or rotation.
Slotted wall plate: multiple elongated slots plus a center hole fit a wide range of anchors and make leveling easy.
Right-angle offset: keeps the mast parallel to the wall while providing clearance for cables and connectors.
Low-profile design: compact footprint for soffits, parapets, and narrow columns.
Universal use: compatible with antennas, sector panels, small dishes, IP cameras, and environmental sensors.

Compatibility

Included U-bolts fit 2.0" (50.8 mm) outside-diameter masts as pictured.
Need a different mast size? Swap to alternate stainless U-bolts (common sizes from 1.25" to 2.5" OD) to adapt the same bracket.

Typical Applications

Mounting a short mast for Wi-Fi / 5 GHz / 2.4 GHz or Wi-Fi HaLow panels
LTE/5G, LoRaWAN, GNSS/GPS antennas
CCTV and PTZ cameras, weather stations, small solar hardware
Coastal and desert sites where rust resistance is critical

What’s Included

(1) Stainless steel L-shaped wall bracket with multi-slot plate
(2) Stainless U-bolts with backing plates
(4) Stainless nylock nuts and flat/lock washers

(Wall anchors/lag bolts for your specific surface—wood, concrete, or masonry—are not included so you can choose the correct type and length.)

Installation Notes

Choose anchors appropriate to the substrate (e.g., stainless lag bolts for wood; wedge or sleeve anchors for concrete/masonry).
Use all four corner slots on the wall plate wherever possible for maximum pull-out and shear resistance.
If mounting near the ocean, rinse hardware after installation and periodically check torque.
For thin-wall masts, add saddles or protective shims under U-bolts to prevent denting.

Materials & Finish

Stainless steel bracket and hardware (weather-proof, UV-stable).
Smooth edges and rounded U-bolt threads to protect coax jackets during routing.

See related mounts: Low-cost L-MOUNTS for pole or wall.

Related Wall Mounts:

Antenna Mount for Pole or Wall: C Jaw Bracket & UBolts

Data Alliance

Write a Review